CDT Credit Form

Post-Milling completion of e.max blue lithium disilicate 

Team Aesthetic Education

Please fill out the following form for continuing educational credits

First Name	*
Last Name	*
Transaction ID # (This is on the email sent to you after purchasing the video)	*
CDT Number	*
Email Address	*
Telephone	*
Date Viewed	*
1. Did you enjoy the video?		A. yes B. no
2. Did you find the video educational?		A. yes B. no
3. Would you refer this to others?		A. yes B. no
4. Did the video play well?		A. yes B. no
5. The restorations shown in this video were fabricated?		A. Milled by Diadem. B. Milled on a KaVo Everest system. C. Milled with a Cerac In Lab system. D. Milled on a Wieland system.
6. These restorations were designed using?		A. Copy milling. B. With Dental Wings software. C. On a Sirona system. D. Using a 3 Shape system.
7. The over-bulk at the margins after the milling process is the result of?		A. Milling inaccuracy B. Is left to prevent chipping of the margins during the milling process. C. Poor calibration of milling equipment. D. Poor calibration of scanning equipment.
8. Staining and glazing is done?		A. On a composite die. B. After crystallization. C. On a stone die. D. Prior to layering.
9. Crystal glaze is applied to the restorations?		A. After stain is fired to set it to the surface. B. After the restoration is stained and crystallized. C. Prior to applying stain into the wet glaze. D. Prior to layering incisal ceramic.
10. Which is your favorite online education source?
Comments